Quarry Tiled Hallway Restoration in Surrey

As the West Surrey Tile Doctor I cover quite a large area including Haslemere which is a town on the South-Western edge of the county in the borough of Waverley. I was down there to visit a customer who had recently bought an old property there and during the renovations uncovered six foot of quarry tiles by the front door. There was a patch of concrete that also needed investigating.

Quarry Tiled Floor Before Cleaning Haslemere Quarry Tiled Floor Before Cleaning Haslemere

Cleaning Hallway Quarry Tiles

I began by carefully removing the layer of concrete with a scraper and a covering of Tile Doctor Acid-Gel hoping it would expose more quarry tiles underneath. Sadly, this wasn’t the case and all I exposed was an area of ruined quarry tiles and four buried bricks. These would have to be removed then filled to bring them to the same level as the remaining tile so I could lay new tiles their place. A couple of noisy hours later following drilling and violent chisel work I’d removed enough to lay flat tiles.

I spent the next hour cleaning and preparing the remaining good tiles. After years of being covered by carpet there was a fair amount of adhesive to remove. This was loosened with Tile Doctor Remove and Go and small abrasive hand-held Diamond blocks to get into the corners.

The Remove and Go was applied to the tiles, left to soak in for ten minutes and then worked into the tile and grout with a stiff brush. The then the soiled solution was rinsed off and extracted using a wet vacuum. Following this work the tiles looked clean but worn out and colourless which is not unusual for this stage of the process and would be resolved once a sealer had been applied.

Tiles were then cut to measure then fixed in place with a rapid adhesive in line with the originals. Once they had set they were grouted in with a grout that closely matched the original. The rest of the floor was inspected at this point and any holes filled with more grout until flat. The grout and tiles were left to dry which was a good opportunity for me to eat lunch.

Sealing Original Quarry Tiles

It was only a small area so later that afternoon the tile and grout and I was able to finish the restoration with the application of two coats of sealer. On this occasion I chose to use Tile Doctor Colour Grow which is an impregnating sealer that soaks into the pores of the clay Quarry tiles protecting them from within and also enhancing the red colours in the tile.

Quarry Tiled Floor Before Cleaning Haslemere

The result was a significant improvement and the customer was very happy, leaving the following testimonial on the Tile Doctor feedback system.

“Rupert was absolutely brilliant. Very friendly and professional, worked cleanly and totally rejuvenated our quarry tile entryway. Would definitely call him again and recommend to friends.”
 
 
Source: Quarry Tile Cleaning and Restoration Service in Surrey

Removing Glue from Quarry Tiles

This customer in Warninglid, near Cuckfield asked me to clean a Quarry tiled floor that had been hidden for years under carpet. The carpet had been thoroughly stuck down with glue and sticky gripper rods so the tiles were in quite a mess. Whilst I thought that most of the floor could be greatly improved I voiced my reservations about several patches of heavy glue and some blackened area where burning logs appeared to have rolled from the hearth onto the stone.

Old Quarry Tile Floor Warninglid Before Restoration Old Quarry Tile Floor Warninglid Before Restoration

Deep Cleaning Quarry Tiles

I spent several hours stripping and cleaning the floor using Tile Doctor Pro-Clean first with hand brush then buffer, but struggled to remove the glue around the edges which wouldn’t shift. The solution appeared to be using a hand scrapper and so after a full day of scrapping and rubbing the floor was clean and before I left I gave it a good rinse with water to remove any product. I left it to dry for a couple of days and then the day before I was meant to return to seal the tiles I got a call from the customer who was concerned that the glue marks were more apparent now the floor was dry. I was between jobs so I popped round to have a look and had to agree it seemed there was still evidence of glue on the floor. Something stronger was clearly needed so I spot cleaned with Tile Doctor Remove and Go which is a strong coatings remover that is safe to use on Tile and Stone. Whilst not removing the glue entirely it made a huge improvement and the customer was happy with the result. I washed the impacted areas and used a heat gun to get the tiles dry so I was still able to return the next day to seal them.

Sealing Quarry Tiles

I sealed the Quarry tiles with three coats of Tile Doctor Pro-Seal which adds a subtle finish to the floor and will provide the tiles with long lasting protection. Luckily the next day was quite warm and the room was well ventilated by several windows and a double door so the tiles dried quickly.

Old Quarry Tile Floor Warninglid After Restoration Old Quarry Tile Floor Warninglid After Restoration

As you can see from the photographs on this page, the floor was really transformed and needless to say the customer was very satisfied with the result.
 
 
Source: Tile, Stone and Grout Cleaning Service in Sussex

Stained Quarry Tiled Steps Revitalised

The photographs below are from a set of steps outside a house in the small West Lothian town of Kirkliston near Edinburgh airport and as you can see from the photograph the Quarry Tiled steps and Grout were looking tired and now in need of a good deep clean.

External Quarry Tile Steps Before Cleaning

Cleaning Quarry Tile and Grout

To get them clean we scrubbed in a strong solution of Tile Doctor Pro-Clean, it was a small area so this was done by hand using water to rinse away the soiled cleaning solution. The process was repeated until the dirt and grime had been removed and particular attention was applied to the grout using a stiff brush and plenty of elbow grease. Cleaning tiles outside does have its advantages as there is less preparation required but drying can take longer if it’s a cold day or shady spot.

Grout Colouring Quarry Tiles

Despite our best efforts to get the grout clean there was still evidence of staining so once it was dry the grout was coloured with 2 coats of grout colourant. The top layer of grout is actually porous so it will become ingrained with dirt over time that makes cleaning very difficult, the grout colourant product we use however forms an epoxy barrier over the grout which seals the grout and makes it easy to clean. Once complete and dry the steps were finished off with a wipe down using Tile Doctor Neutral Cleaner.

External Quarry Tile Steps After Cleaning

 
 
Source: Tile, Stone and Grout Cleaning and Sealing in Edinburgh

Cleaning Kitchen Quarry Tiles

This job was to strip and re-seal these Quarry tiles installed in a commercial kitchen which was undergoing refurbishment at a canteen in Rushden, Northamptonshire. The tile finish had dulled and there was a lot of staining to the grout.

Quarry Tiles in Rushden before cleaning

Cleaning Quarry Tiles

As there was little in the way of kitchen units to protect I go straight down to stripping down the floor using a strong dilution of Tile Doctor Pro-Clean which is a multi-purpose cleaner/stripper that’s safe to use on stone, tile and grout. The solution was applied with a mop and left it to dwell on the floor for twenty minutes in order to give it chance to soak into the tile surface and get to work on the existing sealer and dirt. It was then worked into the floor using a rotary machine fitted with a black scrubbing pad and stiff hand brushes were used along the grout lines to get the grout clean. The resulting soiled solution was picked up with a wet and dry vacuum and the floor was then rinsed with clean water to neutralise the tile and stubborn areas re-treated. Once I was happy the floor was given a final rinse and then left to dry overnight ready for sealing the next day.

Sealing Quarry Tiles

After checking the tiles had dried I proceeded to seal the floor using four coats of Tile Doctor Seal and Go which will protect the floor from staining going forward and also adds a nice shine to the tile.

Quarry Tiles in Rushden After cleaning

 
 
Source: Commerical and Residential Quarry Tile floor cleaning services in Northamptonshire

Cleaning and Sealing Quarry Tiled Floor

This old quarry tiled floor was in the dining room of a Victorian terrace house in central Ipswich, Suffolk. The tiled floor had been covered by carpet for the previous 12 years and the owner wanted it restoring back to its original condition.

Quarry Tile Cleaning

Quarry Tiled Floor Before Restoration Quarry Tiled Floor Before Restoration

The carpet backing had been glued to the quarry tiled floor and it took two days of hard graft using 2 litres of Remove & Go to remove the backing followed by 2 litres of Pro-Clean to clean up the tile. Once we had finished cleaning we washed down the floor to remove any remaining cleaning products and left it to dry overnight. We find a Wet and Dry Vacuum helps a lot when doing this; it’s a great tool for removing liquids from floors.

Quarry Tile Sealing

Quarry Tiled Floor After Restoration
We came back the next day and sealed the floor with five coats of Seal & Go, about 1 litre, which brought out the beauty in the floor, you can see the remarkable difference in the photographs.
 
 
Source: Quarry Tile Floor Restoration in Ipswich