Old Paint Covered Quarry Tiles Renovated in Much Wenlock

This was a property adjacent to Benthall Hall which is a historic building owned by the National Trust near Much Wenlock. Many of the buildings in this town date back hundreds of years including Benthall Hall which is recorded in the Domesday Book of 1086.

Brick Pattern Quarry Tiled Floor Before Renovation Much Wenlock

The property hadn’t been lived in for several years and the new tenants wanted to sympathetically improve the look of the Brick Shaped Quarry Tiles on the lounge floor and in the toilet where the floor had been laid with nine-inch square quarry tiles. Both floor areas had been painted over previously and due to dampness issues the paint was flaking off leaving a very unappealing look. No doubt this contributed to the reason the property has been left un-occupied for so long.

Quarry Tiled Floor Before Renovation Much Wenlock

Cleaning a Quarry Tiled Floor

To give the floor a deep clean I would need to remove all the flaking paint; there were several ways I could go about this so after some consideration I decided to try Tile Doctor Remove and Go.

Remove and Go is a multi-purpose coatings remover that can strip sealers off tiles as well as remove paint and other coatings, it’s also designed for use on Tile, Stone and Grout so safe to use. I applied a strong dilution of the product to the floor and left it to soak in for a good ten minutes. It was then scrubbed into the floor using a black seventeen-inch scrubbing pad fitted to a rotary floor machine. The floor was then rinsed down with water and the soil extracted using a wet vacuum. With the floor clean I could see I had been successful in removing most of the paint but there were areas where further work was needed and so I repeated the process three or four times and used a steamer on the stubborn areas until I was happy with the condition of the floor. After rinsing for a final time, I inspected the floor and could see the tiles looked a hundred times better.

My next thought was to seal the Quarry tiles to protect them from future staining and enhance their look. The problem however with old floors like these is that they don’t have a damp proof membrane and can have damp problems. The floor needed to be dry before applying a sealer and with all the water used to rinse the floor it may take some time to dry out. I discussed this issue with the customer and we agreed that I will return to monitor the floor and arrange to seal it when it was dry. In-fact I did return after a week and tested the floor with a damp meter which confirmed the floor still was still too damp.

Sealing a Quarry Floor Sealing

They were due to move into the property in a months’ time, so I visited them again to check the floor and unfortunately the damp level was still too high. I concluded that there were several factors preventing the quarry tiles from drying out: the tiles were laid on sand, the property as I mentioned had not been lived in for years also there had been a lot of rain over the last couple of months.

Brick Pattern Quarry Tiled Floor After Renovation Much Wenlock

We agreed that once they move in and start to heat the building up, the floor have a much better chance for drying and when it looks dry, they will give me a call and I will check it for them and seal it if possible.

Given the damp issues my thoughts are to seal the floor with a coat of Tile Doctor Colour Grow and then finish with Seal and Go Extra, both are which breathable sealers and will leave the floor with a nice sheen finish.

Quarry Tiled Floor After Renovation Much Wenlock

 
 
Source: Quarry Tile Cleaning and Sealing Service in Shropshire

Neglected Quarry Tiles Restored in Shrewsbury

Details below of a red and black Quarry tiled floor at a house belonging to a customer in the Shropshire market town of Shrewsbury, which dates back to medieval times. The owner had recently moved back to the area and purchased the house with the intention of restoring all its original features including the Quarry tiles floor which had several coats of red floor paint and had been covered with carpet for several years, I guess the previous owner wasn’t sure what else to do with it.

Black and Red Quarry Tiled Dining Room Before Cleaning in Shrewsbury

I was also asked to refurbish the Victorian Tiled hallway and porch which was in an equally neglected state.

Victorian Tiled Hallway Before Cleaning in Shrewsbury

Naturally this is exactly the sort of thing we do so I was confident the floor could be significantly improved with our assistance and after popping round to take I look provided a quote although due to other priorities it was a whole year later before I was asked to come and do the job.

Black and Red Quarry Tiled Dining Room Before Cleaning in Shrewsbury

Cleaning a Quarry Tiled Floor

There was cement based building residue, plaster and efflorescence on the floor so I decided to treat the floor with a strong dilution of Tile Doctor Remove and Go which was left to soak into the tiles for a while before being scrubbed in using a rotary machine fitted with a black pad; the resultant slurry was washed away using more water and a wet vacuum.

The whole process was repeated until I was satisfied that any stubborn areas had been dealt with and then the floor given an acid wash with Tile Doctor Grout Clean-up to remove the efflorescence.

Once I was happy with the condition it was given a final rinse to remove any trace of cleaning products and then left to dry for four days.

Sealing a Quarry Floor Sealing

The tiles have to be dry before sealing and after testing the floor with a damp meter I confirmed that four days has been sufficient and the floor was indeed dry. The next step was to apply three coats of Tile Doctor Colour Grow which is an impregnating sealer that occupies the pores in the tile and enhances the natural colour of the tiles in the process.

Black and Red Quarry Tiled Dining Room After Sealing in Shrewsbury

I was able to use the same cleaning and sealing process on both floors and I think you will agree it made quite a difference and both floors have been transformed.

Victorian Tiled Hallway After Cleaning in Shrewsbury

 
 
Source: Quarry Tile Renovation and Restoration Service in Shropshire

Restoring Quarry Floor Tiles Hidden Under Carpet

This customer had just bought a house in the small Shropshire village of Nesscliffe. Like many new property owners, she was keen to make some changes to the interior decoration, deciding to pull up the carpet they she didn’t like that covered almost the entire ground floor of the house. Upon doing so she and her partner discovered a large area of original Quarry tiles.

Modern quarry tiled floor in Nesscliffe before cleaning

They decided that instead of replacing the carpet with a new one, they would keep the original floor and attempt to restore its condition. However, their efforts to restore the tiles by themselves proved ineffective – many of the cheaper, supermarket cleaning products were not suited for the job of removing years’ worth of dirt and stains.

Modern quarry tiled floor in Nesscliffe before cleaning

At that point they decided to call me. I visited the property and ran a test clean to see what could be achieved. The customer was more than happy with the initial results and booked me in to undertake the full restoration.

Cleaning Dirty and Stained Quarry Tiles

The most noticeable problem with the tiles was a series of paint splashes and plaster deposits covering almost the entirety of the floor, the result of previous decoration work and the installation of carpet.

I removed these by applying a strong dilution of Tile Doctor Pro Clean and working it into the tiles using a scrubbing brush fitted to a rotary machine, with the alkaline cleaner reliably breaking down the stubborn paint splashes.

I then worked the product into the grout lines too using a grout brush. To tackle the plaster and cement-based residue I used Tile Doctor Grout Clean Up, a phosphoric acid cleaner which removes heavy stains.

Following the cleaning, I left the floor to dry for a week to allow for any excess moisture to evaporate.

Sealing Quarry Tiles

On my return to the property I immediately checked whether the floor was dry enough to be sealed. We always do this as excess moisture can very easily effect the performance of the sealer.

Thankfully the floor was completely dry and I was able to seal the tiles using five coats of Tile Doctor Seal & Go. Seal & Go is a topical sealer, meaning it builds up a layer of protection again dirt and stains on the surface of the stone. We recommend it for tiles such as Quarry, Victorian and Slate. While offering surface protection it also provides a pleasing low-sheen finish.

Modern quarry tiled floor in Nesscliffe after cleaning

The customer was really pleased with the result. Within a week the newly discovered Quarry tiled floor had been transformed from an apparent lost cause to a real asset to the home of the new property owners.

Modern quarry tiled floor in Nesscliffe after cleaning

 
 
Source: Quarry Tiled Floor Cleaning and Restoration Service in Shropshire

Removing Paint from Quarry Tiles

Details below of a Victorian Quarry tiled floor belonging to a customer in Oswestry who had recently moved back to the area and wanted to restore the original features of the house including the Quarry tiles floor which had several coats of red floor paint and was later was covered with carpet for a number of years. The customer described the floor as:

“I have 2 areas of quarry tiles that need a serious make over, in the hall and the back room. There are patches of red paint and areas of mineral deposit and lots of ingrained filth!””

Red Black Quarry Tiles Oswestry Before Red Black Quarry Tiles Oswestry Before

Cleaning a Quarry Tiled Floor

I managed to clean the floor with a strong dilution of Tile Doctor Remove and Go which was left to soak into the tiles for a while before being scrubbed in using a rotary machine fitted with a black pad; the resultant slurry was washed away using more water and a wet vacuum. The whole process was repeated several times as the paint was really stubborn and in places I had to remove the paint removal with a scraper. Once I was happy with the condition it was given a final rinse to remove any cleaning products and then left to dry for five days leaving an air mover with the customer to accelerate drying.

Red Black Quarry Tiles Oswestry After Cleaning Red Black Quarry Tiles Oswestry After Cleaning

Sealing a Quarry Floor Sealing

The tiles have to be dry before sealing and even though I returned five days later the damp meter still indicated that there was moisture in the tiles which I suspect was due to there being no membrane in place under the old Victorian tiles. I agreed with the customer to come back a further week later which proved sufficient and the floor was dry enough to take the sealer.

The customer wanted a matt finish so I sealed the floor with two coats of Tile Doctor Colour Grow which is an impregnating sealer that occupies the pores in the tile and also enhances the colour of the tile.

Red Black Quarry Tiles Oswestry After Sealing Red Black Quarry Tiles Oswestry After Sealing

The customer was out when I applied the sealer but when the she got home she sent me the following message:

“The floor looks brilliant. So much better than I had ever hoped. Thank you.”
 
 
Source: Tile, Stone and Grout Cleaning and Sealing in Surrey

Removing Cement and Mortar from Quarry tiles

The photographs below of a Red and Black Victorian Quarry tiled floor were taken at a 109 year old cottage in the town of Telford. Unfortunately the tiles were in a really neglected state after the completion of building works but we do like a challenge and agreed to do the work.

Victorian Quarry Tiles Telford before cleaning Victorian Quarry Tiles Telford before cleaning

Cleaning a Quarry Tiled Floor

The whole floor was covered in layers of mortar and plaster so a strong solution of Tile Doctor Remove and Go was applied and scrubbed into the floor using a rotary machine fitted with a black scrubbing pad.

The initial clean revealed a lot more of the mess that had been left over from the builders mixing of mortar and concrete so I decided to try an acid based product called Tile Doctor Grout Clean-Up which is mainly used for the removal of grout from the tile surface but works on other cementitious materials as well. This worked well but required several applications to remove it all and once complete the floor was given a thorough rinse with clean water to ensure it was clear of the resultant slurry and there was no trace of cleaning product. A wet vacuum was used to remove the water from the floor and get it dry so it could be sealed.

Sealing a Quarry Floor Sealing

Once the floor was dry I sealed it using two coats of Tile Doctor Colour Grow which was chosen as the customer wanted a matt finish; Colour Grow also brings out the colours in the tile and it’s an impregnating sealer that occupies the pores in the tile to provide excellent stain protection.

I think you will agree the photographs below shows an amazing transformation that exceeded all expectations.

Victorian Quarry Tiles Telford After cleaning Victorian Quarry Tiles Telford After cleaning

Source: Residential and Commercial Tile and Stone Restoration in Shropshire