Restoring Quarry Tiles covered in Glue and Lino

This house near Banbury was the tied accommodation for an old village police station from the days when the local bobby would live in the house next door. I’m sure the Quarry tiled floor had a rich history which no doubt contributed to its poor state and was eventually was covered up with linoleum which had been stuck to the tiles with adhesive. Recently however the house had been sold and redecorated and the new owner wanted the floor restoring to its former glory.

Restoring Quarry Tiles

I started by covering the floor with a dilution of Tile Doctor Remove & Go which was left to dwell for 20 minutes taking care to ensure it didn’t dry out; it was then scrubbed into the floor with a black pad attached to my Rocky floor machine. This process removed most of the glue on the floor so after removing most the slurry and inspecting the floor I could see it would be necessary to repeat the whole process again and get down on my hand and knees to scrape off the thicker parts of the glue.

Once the glue had been removed the floor it was rinsed with clean water which was then removed using a wet vacuum. The next process was to clean the dirt out of the pores of the tile using a dilution of Tile Doctor Pro Clean and warm water. Again the solution was left to soak into the tiles before scrubbing, rinsing and removing with the wet vacuum.

After a lunch break the surface of the floor was drying and I noticed that the tiles we’re going white which would need to be dealt with before sealing. Older floors tend not to have a damp proof course which can lead to damp rising up through the tile depositing white salts on the surface in the process. This problem is called efflorescence and to resolve the tiles needed to be treated with Tile Doctor Grout Clean Up which was scrubbed into the tiles and washed off as before. The floor was then vacuumed dry and then left so it could dry out completely.

Sealing a Quarry Tiled floor

I returned a couple of days later and the floor was dry and clean but looking rather dull; to put some life back in the floor it was going to need to be sealed. I first put a coat of Tile Doctor Colour Grow down which brought the colour back into the tiles plus this is a good sealer on its own as it impregnates the pores of the tile and makes a terrific base seal. To complete I followed up with a number of coats of Tile Doctor Seal & Go which Is a topical sealer that provided the shiny finish the customer wanted.

The quarry tiled floor is now restored from what was once a very old neglected floor to a nice clean easy to maintain surface.
 
 
Source: Professional Tile, Stone and Grout maintenance service in Oxfordshire