The photos are of a large Quarry tiled Kitchen floor at a property in Woodham Walter which is a small village between Danbury and Maldon. The floor had been installed 20 years ago by the current owners and although in reasonable condition they felt it was time to have them renovated as the tiles had lost their sheen and now looked flat and unattractive.
I went over to survey the floor and quote for deep cleaning and then re-sealing. The photographs don’t really show it, but it was clear to me that the sealer had worn off and it was the sealer that had brought the depth and colour to the quarry tiles.
We discussed the process which would take two days and decided on a sealer that would best match their expectations. They were happy with my quote and the work was booked in.
Cleaning a Quarry Tiled Kitchen Floor
On arrival I set about prepping the floor for cleaning which for this floor primarily meant removing the kick boards from underneath the kitchen units.
Working in sections I set about cleaning the quarry tiles using Tile Doctor Remove and Go. This as the name of the product suggests is a coatings remover that cleans the floor and removes any sealer left on the tiles. Although it had been some time since it was last sealed its important that all the previous sealer is removed before applying a new sealer. This ensures you don’t end up with different levels of sealer and some areas appearing darker than others.
The Remove and Go was left to soak in for ten minutes before being worked in with a rotary buffing machine fitted with a black scrubbing pad. The grout was also scrubbed into the grout lines by hand using more solution and a stiff brush. This action lifts the dirt out of the floor and turns the cleaning solution and old sealer into a slurry, this is then rinsed off with water and extracted with a wet vacuum.
Next, I treated the tiles to an acid rinse using a 1:5 dilution of Tile Doctor Grout Clean-up. This further cleans the tiles and will neutralise the pH level of the floor following the use of Tile Doctor Remove and Go earlier which is a strong alkaline. The acidic nature of the product microscopically etches the tiles to ensure a stronger bond with the sealer.
The Grout Clean-up was brushed into the floor and then rinsed off with more water before being extracted with the wet vacuum. After another rinse with water the wet vacuum was then utilised to get the floor as dry as possible before leaving it to dry off fully overnight.
Sealing a Quarry Tiled Kitchen and Dining Room
The next day the moisture level of the Quarry tiles was checked using a damp meter to ensure the floor was dry enough for sealing. This is always worth doing as applying sealer to a damp floor can result in a patch appearance.
The moisture readings were fine and so work started on sealing the tiles using Tile Doctor Seal & Go which works really well on Quarry tiles and results in a warm satin sheen finish. This product is also water based so you don’t get that solvent smell being given off as it dries.
Sealers work by keeping the dirt on the surface of the tile where it can be easily cleaned away and on the subject of aftercare cleaning I recommended the use of Tile Doctor Neutral Tile Cleaner. It’s important to use a neutral tile cleaner on sealed floors like this as stronger bleach-based products will wear the sealer off prematurely.
Source: Quarry Kitchen Tile Cleaning and Renovation Service in Woodham Walter Essex
Tile Doctor has a range of sealers that cover all types of finish and situations. If your not sure which product is best for your tiles do call our helpline on 0345 512 0122 to discuss.